on 06-09-2009 10:54 AM
Hello SAPions,
I am unable to get into debugging mode from WebDynpro Portal screen to R/3 BADI in SRM 7.0 .
I placed a breakpoint in the BADI, and logged into the portal screen.
However, in SRM5.0, to get into debugging mode from ITS, we place a break point in the BADI, when we browse the ITS link from the IE browser, we will be able to get into debuggin mode.
Any other way ?
Regards,
Ashwin.
Hi. Can you not debug from the GUI, transactions BBPSC01 / BBPSC02 are the transaction codes. There are a bit messy but it normally works, although I have not tried on SRM 7.
That said, you should be able to debug Webdynpro. I presume you turned on external debugging in your user settings?
Regards,
Dave.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
all was there, but the a role was missing.
Thanks for ur reply.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
Please check the following:
1. Application server name, the SAP GUI and the portal should be logged into the same application server.
2. You should be logged in with the same User in both SAP GUI and the Portal.
3. External debugging should be enabled for the User in SAP GUI.
4. Also try checking the check box , IP Matching . This can be done as below:
Utilities -> Settings -> ABAP Editor -> Debugging -> IP Matching.
Also please check the following in the above link , if you have the same user name here with which you have logged onto Portal and the New Debugger Radio Button is Selected.
Hope this helps.
Best Regards,
Sapna
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.