cancel
Showing results for 
Search instead for 
Did you mean: 

Enhanced Block Maintainence does not consider the resource utilization

Former Member
0 Kudos

Guys,

We are using SCM 5.0 and we have a problem. We use the resource utilization and we see the block alternate unit of measure quantity adjusted correctly in resource.

But when we go to the 'Enhanced Block Maintainence', i do not see any consideration for resource utilization.

Example -

The alternate unit of measure here is TONS and this conversion is 144 s/ton. The resource utilization used here is 90%

So if the block is created with span of 12 hours, the alternate unit of measure would be 3600/144*12 = 300 TONS. But since the resource utilization is 90% as shown below -

So the block duration goes down by 10% which then makes it 270 TONS.

But if we see the Enhanced Block Maintenance, it does not consider the resource utilization. It shows the block tonnage as 300 TONS. So this shows that the resource utilization is not considered during calculating the alternate unit of measure.

I saw the note 521674 which happens to be a very old note, but the corrections do not show up.

I also made the resource change the PPDS Bucket Capacity.

Kedar

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

I found the solution that such things might happen if the SNP capacity is different than PPDS