shipment cost :Cond. type FS00 - condition record exists (removed manualy)

[Former Member]

hey all ,

my requirement is to charge for every container (packing material) in the shipment .

i coped condition FS00 (container) and called it Z100 .

the condition is defined with following parameters :

cond.class : B - prices

calc.type : S -number of shipping units

calc base : C -handling units

the condition opens in a pricing procedure under item category ZK01 which is defined the shipment header as cost relevant.

AND the problem :

when i opens the shipment cost document the condition doesn't appears .

in the analysis i get this message :

" condition record exists ( removed manually ) "

when i add the condition manually and double click on him there is a field that

specify that the condition is inactive because : " inactive due to calculation basis (shipping)

after checking the relevant notes :

• i don't have a requirement in the procedure or the access to this condition .

• i didnt delete is manually

so the above isn't the reasons that the condition isn't showing .

other condition types ( old condition types ) is active in this procedure ( new procedure )

does any body have an idea ?

Best Regards

ASA

[Former Member · Accepted solution]

Hi,

Exclusion groups or an incorrect formula on pricing procedure migth cause this.

Regards,

RP

[Former Member · Accepted solution]

hey RP ,

no exclusion and no formulas in this pricing procedure ?

any other ideas ?

i post this in an other forum and got this :

Hi,

There should not be two or more conditions with the condition class B in the

same pricing procedure.If there are two coditionswith the condition class B

in the same pricing procedure then it will invalidate all other conditions

in the pricing procedure.Check if any other condition(other than Z100) has

the same condition class. If yes use some other condition class for it.

Regards

Avinash Gyale

is it make any sense ?

[Former Member · Accepted solution]

solved :

There should not be two or more conditions with the condition class B in the

same pricing procedure.If there are two coditionswith the condition class B

in the same pricing procedure then it will invalidate all other conditions

in the pricing procedure.Check if any other condition(other than Z100) has

the same condition class. If yes use some other condition class for it.

[Former Member]

There should not be two or more conditions with the condition class B in the

same pricing procedure.If there are two coditionswith the condition class B

in the same pricing procedure then it will invalidate all other conditions

in the pricing procedure.Check if any other condition(other than Z100) has

the same condition class. If yes use some other condition class for it.