Client copy from productive to QAS system

[Former Member]

Hi!

We would like to copy a client from productive system to quality assurance system.

Questions:

1) What is the best procedure?

1a) export/import

1b) remote copy

2) Where can I find the appropriate documentation?

Thank you very much!

[Former Member]

Hi,

Check this

Thanks

Sushil

[Former Member]

Export / Import is recommended in you case.

And you take care of prerequisite steps

> You have to have required space available in /usr/sap/trans Directory for Source (PRD) and Target (QAS) systems

> Approximately maintain space at OS level @ 10:3 ratio of client size, ex: if client size is 140Gb it will take approximate size of 20G at OS level when exported.

> Before Import extend the PSAP<SID> tablespace to the required size in target system. For this you can run a resource analysis in client copy.

> Once Import is done, donu2019t forget to run the BDLS for changing the logical systems.

Following commands used:

SCC8 for Export

Use STMS for import, after successful import Use SCC7 for post processing of client copy.

Thanks,

Surendra

[Former Member]

Refer to http://www.sap-img.com/bc049.htm

It will be highly useful

Rohit

[sunny_pahuja2]

Hi,

Please find documentation on client copy on below link:

http://help.sap.com/saphelp_nw70/helpdata/EN/69/c24c684ba111d189750000e8322d00/frameset.htm

I think both methods are ok. It depends on you which method you use.

Thanks

Sunny

[Former Member]

Hi,

Remote method is not preferred if you are doing a large client copy

I will suggest that you opt for export/import method.

Please find the link for more detail procedure.

http://help.sap.com/saphelp_nw04/helpdata/en/69/c24c824ba111d189750000e8322d00/content.htm

With Regards,

Saurabh

Edited by: Saurabh.Arora on Jun 4, 2009 11:34 AM