on 06-02-2009 9:27 PM
Hello Gurus,
Is there a way to update existing inspection lot when master characterstic changes?
Any help would be really appreciated!
Regards,
Owais
Hi
You can change the Existing Inspection plans by doing setting at Cleint level as Replace MIC
When you cahnge MIC it will give popup of where used.You can change the task lists.
But this changes will not automatically reflect in an inspection lot.
for this you have to
Go to Qa02
Enter Inspection lot
Click on reset
save
check status of lot CRTD in QA32
now go to QA02
enter
click on Inspection Specification
selct sample
save
check status in QA32 as REL
Regards
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
If you are changed in MIC , it will not afected in existing in Lot . but you can change that MIC where it used in plan by QS27.
Regards,
Utkarsh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
DO you mean that if you change MIC in the inspection plan then it must reflect automatically in the inspection lots which are already created.?
If it is like that then answer is no it will not update in the existing lotautomatically, to update that you have to go in the change mode of inspection lot QA02 remove the assignment of inspection plan from that lot, make changes in the inspection plan and then again reassign that plan with the inspection lot.
I hope this will clear your doubt for any further issues please revert back
Thanks
Vinay
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.