on 06-02-2009 12:38 PM
Hi,
I have problem with mass processing job in APO DP.
Phase In/Out profile is not considered during mass processing job in DP, but when I apply that profile manually in Interactive planning book (/sapapo/sdp94) it changes the forecast accordingly.
Why phase in/out profile is not consdered during mass processing job?
If anyone has any idea on this problem, then please let me know the rootcause and solution.
The system is SCM 5.0 APO.
Thanks
Regards
Jignesh
Hi Jignesh,
Did you check the spool list after batch job run, to see if Phase in/out is appled to the material for which life cycle is assingned. Also I would advice to go and double check all setting is dates are defined correctly etc.
I would presume you might have done all these, if you still have the issue check notes 1222953 and 1223746 and apply. This should resolve your issue.
REgards
siva
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello there,
I don't know if this could be the cause but when you say you launch phase in/out in a job that means you have created a forecasting profile to be used in an activity and then in a job. This forecasting profile must have set the option of lifecycle planning, if not phase in/out won't be considered.
Hope this helps
Miguel Garcí
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
7 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.