on 05-29-2009 1:46 PM
Hello Forum, we switch from standalone ITS (620) to integrated ITS (700). In the "old" configuration wie used the service parameter ~disconnectonclose. Where can I set this parameter in the integrated ITS? Probably in TA SICF, but I dont find the location.
Thanks for your help
Andreas
You can find that at,
SICF -> Sap ->bc -> gui -> sap -> its -> webgui -> "Service data" tab -> Gui Configuration -> Add service parameter
Regards
Juan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello, I added the parameter. Then I log on via Webgui: I need to authenticate. I log off from the R3, then in the same Browser-Session I use the Webgui-Link again. This time I have access to R3 without authentication!
I thouht the parameter ~disconnectonclose would avoid this behavior. Or?
Andreas
(I set the parameter to "1")
Edited by: Andreas Stahl on May 29, 2009 3:54 PM
Andreas
We are not using ITS, so please donu2019t hold me to this.
From my search, the parameter may no longer have any effect.
See the following link:
http://help.sap.com/saphelp_nw04/helpdata/en/4b/0b543fdbae1e26e10000000a114084/frameset.htm
See section:
u201CParameters for SAP Internal Use Onlyu201D
Hope this helps.
PJ
Hi
Probably this link would help you out: https://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/503c7839-4dea-2a10-1f97-f77aebc5...
Ravi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.