Missing IDoc - config question

[Former Member]

I need to send SHPORD.DELVRY03 IDocs from SAP and convert it in XI to a file.

The outgoing IDoc in the SAP system has status

"03 - Data passed to port OK"

"The IDoc was sent to an R/3 System or an external program via a transactional RFC.

The TID is 0A62019724E14444EF7F0311."

Nothing however shows up in XI.

Any idea what to look into, what I need to check?

Don't know where to start, the connections were

set up between the source SAP system and the XI box.

Thanks a lot,

Viktor

[MichalKrawczyk · Accepted solution]

Hi,

have a look at TCODE SM58 on the R3

Regards,

michal

[Former Member · Accepted solution]

My tRFC status in SM58 says "::000"

(???)

[MichalKrawczyk · Accepted solution]

hi,

is the error the same as in here:

if not push the ? button and check the error number

and look for it at service.sap.com/notes

Regards,

michal

[moorthy · Accepted solution]

Hi,

Is it may be because of Authorization Problem?

Just check this Thread.

Also check this-

http://help.sap.com/saphelp_nw04/helpdata/en/6a/e6194119d8f323e10000000a155106/frameset.htm

Hope this helps,

regards,

Moorthy

[Former Member · Accepted solution]

Dear Krishna and Michal,

Thank you very much for the help, indeed it was security, we added SAP_ALL (which includes S_RFC) to the XIAPPLUSER roles on both the XI and the SAP box in it works fine, both the metadata import and the IDoc itself comes over.

My two and a half days of frustration ends here, thank you again, both of you guys!

I wish there were more points to distribute!

Best regards,

Viktor

[MichalKrawczyk · Accepted solution]

glad it works man

next time don't wait 2 days to post on SDN:)

Regards,

michal

[moorthy · Accepted solution]

Good to hear that it works.

Thanks,

Moorthy

[Former Member]

Hi,

Check this weblog for setting.

/people/ravikumar.allampallam/blog/2005/02/23/configuration-steps-required-for-posting-idocsxi

Refer to this for sending idoc to file.

/people/prateek.shah/blog/2005/06/08/introduction-to-idoc-xi-file-scenario-and-complete-walk-through-for-starters

Thanks,

Prateek

[moorthy]

Hi Viktor,

First have a look into SM58 of R/3 as suggested. And also have a look into this blog to more-

/people/prateek.shah/blog/2005/06/08/introduction-to-idoc-xi-file-scenario-and-complete-walk-through-for-starters

Hope this helps,

Regards,

Moorthy