on 05-22-2009 5:37 AM
Hi All,
We have to maintain the Actual Fabric Width and the Vendor Fabric Width (which is stated in the vendor fabric roll) in the system for Usage Decision. I created 2 code groups "VendorWidth" and "ActualWidth", is there a possibility to maintain these figures in the system? Please note these figures differs for each vendor and has to be enterd at plant level.. Also for the Catalog 9 (Defect Types) if i enter a defect class quality score will be calculated on the points given there. Is there a possibility to enter these defects values also from some other entry form???
Thanks and Regards,
DTD
Edited by: TMDTDSL on May 22, 2009 6:45 AM
Hi,
The two code group vendor fabric value & Actua fabric value you can create as code group under the 1- charcteristic attribute in transaction QS41.Then you can define the selection set for the plant level & define this 2 code group at the one selected set in QS51 transaction with different specification.
Now create the seperate MICR in QS21 & mention the character as the qualitative values& specify the selection set code group & codes.
When you do GR for the material the system will ask for the fabric value specify that value as you define many option.
or create as quantitave & specify value when inspection results has been done.
Regards,
Raj
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.