on 05-19-2009 11:37 AM
Hi BI Guru's
I transported the process chain from DEV to QAS, In QAS all the DTPS where not active and also the technical name( only ) is changed, where as other properties are same .
could any one say something on this kind of errors.
thanks
JSK
hi,
Activate all DTP`s in QAS system.
There is no impact an others.
Thanks,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
This is a very common issue. However, you would still be able to schedule the DTP even if its inactive. After the load is executed, the DTP becomes active.
Regards,
Satya
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Just doing a little checklist here:
1) Are all of your transformations as well as the sources and targets of your DTP's active and in QA?
2) In QA did you set the conversion of source system names after transport?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi JSK,
That is very common, I do however not know any other solution then to activate in QAS. If anybody has a better solution I would also like to know...
Best regards,
Mikael
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.