on 05-18-2009 8:07 PM
Hi,
I have the following queries on quantity / value contract :
1)Is it possible to reflect quantity as well as value in the same contract and have control on both these parameters at the same time, as per my requirement? I would like to know much quantity and value is left there in the contract , ( i.e. qyt and its equivalant value and vice versa ) and if any of these two parameters exceeds the quantity /value of the contract, while making order, it should pop a message and stop me to proceed further.( In item category, it is for any one parameter at a time i.e quantity or value . My requirement is for both at the same time for the same contract ).
Please let me know the settings for this.
2) How to see how much has been billed against a particular quantity / value contract, and how much balace is left. also how many contracts are open ? Is it by VA43 ?
Thanks & regards,
KVinod
Hi
Check in VA45N. in ECC 6
regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Thanks for the prompt reply and solution.
Regards,
KVinod
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
You have to decide what type of contract is required ?
If the contract value exceed , it will not allow to create sch.agr ? Still if you want a pop-up , use user exit and control it.
Thanks
Rk
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.