on 04-14-2006 3:26 AM
Hi,
I set my delta to run automatically and it failed because the datasource was not replicated. I just did a replication and activated the IS. Should I delete the failed request and run the delta manually from the InfoPackage? I would think that would be the approach but wanted to make sure I will not doing anything incorrectly. It has a red light from the monitor but yellow from the request tab.
Thank you
Hi Crystal,
You can run it manually and load the delta as tyour request for data would have never reached the source system because of the replication problem.
Bye
Dinesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Crystal,
If delta is failed, you can run it manually, but before that you goto datatarget (Infoobject/ODS/Infocube) and find the bad request in that and make it red forcfully(even though it is in red) then run infopackage, at that time it will ask earlier delta is failed so you want to do repeat delta, click on ok.
Thanks
Reddy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Crystal
Yes you are right. Delete the failed request from the cube and you could run manually again with the same infopackage and you won't loose ant data
Thnaks
Sat
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
88 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.