on 05-13-2009 11:36 AM
Dear All,
While doing File-RFC-File (without BPM) scenario, i am not able to see any messages in SXMB_MONI at ECC though in XI I am able to see the messages in SXMB_MONI.
Please suggest if any extra configurations are required to be done in ECC to activate SXMB_MONI. I have alreday the steps suggested by Micheal's blog /people/michal.krawczyk2/blog/2005/05/10/xi-i-cannot-see-some-of-my-messages-in-the-sxmbmoni in ECC but still no messages are getting displayed.
Reg,
NJ
Hi,
In case of RFC adapters you will not se any entries in sxmb_moni (sxi_monitor) in ECC. These messages are directly sent/received through abap stack.
Hope this helps.
Regards,
Siddhesh S.Tawate
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
as said above you have to check logging_sync parameter in SXMB_ADM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Nishu,
Double check if the LOGGING_SYNC is set to 1
Regards,
Ravi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi nishu,
When your proxy settings activated then that time only you can able to view the data in sxmb_moni.
RFC is used to communicate with trfc and arfc ports. sxmb_moni is a Process integration transaction code.So you cannot use that in R/3.If proxy enabled then, that time local integration server will located in R/3.So that time only you can able to use sxmb_moni transaction code in R/3 system.
Regards,
Prakasu.M
User | Count |
---|---|
86 | |
10 | |
9 | |
9 | |
9 | |
6 | |
6 | |
5 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.