on 05-11-2009 7:57 PM
Hi
i would like to know, wats the procedure to get the loading message when a WDJ iview loads its content.
I have WDJ application , which connects from backend system and gets its Data
when i do a Preview of the IVIEW , i am able to see the LOADING MESSAGE
ON assinging the same IVIEW to a ROLE .. ,i am not able to seee the LOADING MESSAGE
Iam Running my portal on NW sp 16
Can anyone throw some pointer over this...
it would be highly appreciated,,, as there are another unanswered thread on same issue...
Thanks
Kumar
Edited by: Kumar on May 26, 2009 10:09 PM
Just try to put your WDP iView inside a WDP page and then set the iView isolation mode as "URL".
Maybe this could work also without having to add the WDP iView into the WDP page, but I've tried only with the iView togheter with the page.
I hope this will help...
Ciao
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Try Using the Below link via javascript
http://<host:port>irj/servlet/prt/portal/prtroot/com.sap.portal.appintegrator.Loading?692833793
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.