Adding system and client specific TMS approval steps

[Former Member]

Hello,

In defining QA approval steps, how to define a step which is not system and client wide?

When adding a new step, it is automaticaly defined with * in the client and system fields, and when changing the steps, these fields are not editable. However, there are several approval steps for which a specific system and client are entered, but this was done by a consultant, who was here some years ago.

Does anyone know how to do this?

Thanks in advance,

A

[Former Member]

Hi,

can look at this

[https://help.sap.com/saphelp_sem320bw/helpdata/en/ff/d6aa51d14c11d2b443006094b9ea64/frameset.htm]

Regards,

Muralidhar

[Former Member]

Hello,

Thanks for the suggestions, but I have been through these sections in the SAP Library, and it says "If you have more than one QA system configured, additional columns are displayed (System and Client). " but that is not the case when adding a new step, even though there are two QA systems defined in our landscape.

A.

[shaun_wimpory2]

Hi Aleksandra,

Did you ever find a solution to this issue.  I too have multiple QA systems in our landscape (4 system landscape), and yet I can not defined system/client specific approval procedures in STMS.

The system and client options don't even appear when I go into change mode, yet table TMSQASTEPS has the options available.  Direct table update works fine, but it would be nice to know the "SAP standard" way of doing this.

Cheers

Shaun

[Former Member]

check out

[http://help.sap.com/saphelp_sm40/helpdata/EN/9c/a544c9c57111d2b438006094b9ea64/content.htm]