System error when change the Output type condition

[Former Member]

Hi:

When I use tcode NCAR to change the output condition LD00, system give me the error message that "Conditions for the selection entered are blocked XXX

Message no. VK083"

Did someone know this message?

Could anyone help me to find the problem and tell me how to release this block?

Thanks & Best Regards

David Wang

[Former Member · Accepted solution]

Hello David,

If multiple sessions are not open and still this message comes..then go to SM12 press LIST button .Select all and delete all lock entries.Then try with your transaction.

Revert if not resolved.

Regards

Amit

[Former Member · Accepted solution]

Hi Amit:

Thank you very much. I have solved your problem by following your guide.

Best Regards

David Wang

[Former Member]

David Wang ,

The Tcode: NACR, - Change condition records LD00

You would have opened couple of sessions using the same tcode, or you could have opened the condition type using other tansaction VV22.

CLose all the sessions, open afresh and try the Tcode....

Regards

Sathya

[former_member839993]

Hi David Wang,

If i am not wrong you r using NACR t.code instead of NCAR as u said.Now,the message you have received is due to multiple sessions with the same tcode requirement, check whether you have opened multiple sessions for the same t.code.

Come out of all the sessions and enter the tcode NACR you shall not find the message again.

Welcome to SDN

regards,

US