on 04-27-2009 5:19 PM
Hallo,
i have an input-ready query in a workbook.
The Query consists some key figures in the lines. The columns are:
- one for values created by a planning function called "projected" and
- one additional column for manual planning of the key figures calles "manual".
In addition, there are 2 variables:
- Calmonth (for a start-month) and
- another Character for "month of projection" (also based on calmonth)
When i choose the variables 01/2008 as calmonth and projection end 12/2008, i get the automatic calculated values (which already exists in the infocube) in the automatic column and i can type in values in the manual-column. That is fine and is working for all combinations of the variables calmonth and projection end.
But when i choose the variables 11/2008 and 12/2008 or 12/2008 and 12/2008 the manual column is still input-ready, but now the automatic-column is also! input-ready! Thats wrong.
In the query definition, the "automatic"-column is explizit set as "not input-ready".
How can that be?
Thank you in advance.
Regards.
p.s. System is BI-IP 7.0.
Edited by: Benjamin Voit on Apr 27, 2009 6:19 PM
Hi,
This is a very uncommon error and I am exactly not sure why this is happening. however, you could close the executed query to avoid any lock and can work on a new session.
This might be due to the reason that:
For Standard Infocube the read mode is always 0 and for Real time InfoCube is 1. Even if the mode is switched back to 0, the mode switch back to 1 automatically when a plan and reporting query run in same environment.
Hope this helps !!
Regards, Rishi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.