File name dynamic

[Former Member]

Hello,

i need to use a dynamic name in the file output.

i've seen the blog /people/michal.krawczyk2/blog/2005/11/10/xi-the-same-filename-from-a-sender-to-a-receiver-file-adapter--sp14, however i don't understand how can i do the mapping

in my mapping my message types are of messages. must I included in message type target a new field?, where?

thanks very much

[former_member181985 · Accepted solution]

Not required. use the Dynamic configuration UDF in between any two fields or nodes of Source and target message types.

Edited by: Praveen Gujjeti on Apr 24, 2009 6:17 PM

[Former Member]

Hi..

You can use Dynamic Configuration in UDF and map the Root nodes with using that UDF.

You cannot test the mapping in IR part. WHile executing the scenario only you can test whether your mapping is correct or not.

Thanks,

Leela