Accouting integration - How to assign internal order using project number?

[Former Member]

Hi,

I am configuring CProject 3.1 to activate the single-object controlling so that an internal order can be created after replicating a project from CProject to R3. It works now.

But the problem is, this internal order number is suppose to be identical to the project number. How can it be done? I can't find BADi for this purpose. Dose anyone have any suggestion?

[bjoern_panter · Accepted solution]

Hi Kitty,

did you checked out the Badis DPR_FIN*

e.g. the DPR_FIN_GECCO_CALC

I hope this will help.

Regards

Björn

[Former Member · Accepted solution]

Hi Bjorn,

Thank you for your help. I checked the document, however, the Badi seem be applied after an internal Order was created. or I misundersatnd the document?

regards,

[former_member239760]

Hi Kitty,

Can you please give the details why i get the

error which i have mentioned in the "Accounting

Integration Error" message.

If you have any document pls share with me

Regards,

[Former Member]

Hi Rajapopalan

1. did you install the plugin in R3?

2. try smq1 to see if there is any messages jamed in the queue

Regrads,

[former_member239760]

Hi,

We have the cProjects 3.1 system seperately

and ECC5 System seperately. I have connected

through the RFC. There is no messages in SMQ1

Can you see the message given by me

with subject

" cProjects & R/3 Accounting Integration "Company Code not found" "

I have elabroated the details there.

Regards,

[Former Member]

1. ECC5 should have plugin installed

2. where is the om maintained? the integration use org number not abbreviation to find the corresponding org. the org number must be identical!

3. in the project of CProjects, you should maintain "organization unit" in "additional data" tag

good luck

Regards,