CM24 - Capacity planning

[Former Member]

Hi

While executing the transaction code CM24 it is giving the following error. Where do i need to maintain this conversion.

Conversion "HR" to "******" not possible! (Center:

"YL-MEMEF", Cap. Category: "002") (Message no. CY 252)

Diagnosis

*The conversion of unit of the measurement HR to ****** is not possible*

because you have not maintained the relationship between the units of

measure.

System Response

The values affected are set to zero.

Procedure

You must maintain the conversion factor for converting the base unit of

measurement into the unit of measurement for display for the work center

YL-MEMEF and the capacity category 002 in work center/capacity

maintenance.

Mujeeb

[MTerence]

Hi

As per the error Message

GO to TCODE : IR02

Enter your plant and Work Center YL-MEMEF

Go to Capacity Tab - Click Capacity Header - Maintain the Base Unit of measure as HR (Hours).

The Problem will be Solved

- Pithan

[Former Member]

Pithan,

It's already maintained in work center the capacity base unit (HR).

Regards,

Mujeeb

[MTerence]

Hi

TCODE : CUNI

In Units of measurements - Select Time and CLick Unit of measurements

Check the Unit u have used.. HR or HUR or H... Double Click it...

Under Conversion maintain as

Numerator - 3.600

Denominator - 1

Decimal pl. rounding - 3

Check it.. i have used this in my system... check and revert me back

- Pithan