on 04-15-2009 5:50 AM
Hi,
I have a zebra printer (ABC_LBL) which is used for GR Label printing.
I have maintained the same printer name in Output type and I am able to generate the output also.But there is lot of over-lapping happening here, I think it is because of some printer settings.Can anyone let me know do we need to maintain any specific printer settings.
Regards
Ankit
Hi,
I think it are not the printer settings. If you give the proper ZPL commands you can remove the overlapping.
Gr., Frank
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
It is not a single ZPL command. You have to redesign your layout a bit on such a way that it fits.
If you want i can send you an ZPL manual.
It is also possible that you have to change the resolution of your printer. (form 200 dpi to 300 dpi). With a higher resolution the characters and become smaller.
Let me know.
Gr., Frank
hi,
if the data is printing correctly then consult your basis team, and before that check the size of the window where your printing the label.
thanks,
anupama.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
This message was moderated.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
89 | |
10 | |
9 | |
9 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.