UPGRADE PHASE ERROR

[Former Member]

Hi

Now i upgrading our R/3 4.7 server to ECC .While installing i got the

below mentioned error meaagage on phase EU_IMPORT1 .

>>EU_IMPORT ERROR:, log file "EX000009.DPR": only 0 times "R3load.exe:

job completed" found.

Analyze the log file EX000009.DPR for error messages or program abort.

EX000009.DPR .

e:\usr\sap\put\exe\R3load.exe: START OF LOG: 20090414161707

e:\usr\sap\put\exe\R3load.exe: sccsid @(#)

$Id: //bas/700_REL/src/R3ld/R3load/R3ldmain.c#14 $ SAP

e:\usr\sap\put\exe\R3load.exe: version R7.00/V1.4

Compiled Jan 23 2008 23:46:43

e:\usr\sap\put\exe\R3load.exe -i

e:\usr\sap\put\exchange\compack\EX000009.COD -p

e:\usr\sap\put\log\EX000009.DPR -s e:\usr\sap\put\log\EX000009.DST -

datacodepage 1100 -dbcodepage auto -upg_nametab DDNTT~ DDNTF~ -t 1419

(DB) INFO: connected to DB

(DB) INFO: DbSlControl(DBSL_CMD_NLS_CHARACTERSET_GET): WE8DEC

(CNV) ERROR: no code pages in TCPDB

e:\usr\sap\put\exe\R3load.exe: job finished with 1 error(s)

e:\usr\sap\put\exe\R3load.exe: END OF LOG: 20090414161707

So kindly give me the solution

Regards

Palani Selvan

[Former Member · Accepted solution]

Are you doing a combined NUC to UC upgrade?

[Former Member]

Hi sridi

Can you tell me the steps and parameters for this problem , Iam not using combined unicode upgrade . I planned to convert the server unicode later only , Kindly advice me .

Regards

PalaniSelvan

[Former Member]

Hi PalaniSelvan

In your system the table TCPDB is empty.

Run report rscpinst and initialize the language.

SE38->RSCPINST->Select the language and click on activate and check the tcpdb entry in t-code se16.

Repeat the step.

Regards

Ashok

[Former Member]

You must activate all used language codes in your system with program rscpinst.

It should be ok to do it now and retry the eu_import1 phase.

Regards

Sindri