on 03-31-2006 8:23 PM
Hello BW Experts,
Trying to load 1 million records master data. Attribute change run short dump due to lack of space. Then deleted the master data. Again running the load with less records ( 10k ). PSA --> Infobject load not starting due to the error
"Attributes for characteristic ZCUSTNUM are locked by a terminated change run
Message no. RSENQ063"
I have done the below checks:
1) Cleared all the locks in sm12
2) No records to be updated in sm13
3) No other processes running in SM50
4) No short dumps in ST22
Any faced problem like this before. What this problem means. Wondering if there is a table where the lock status is set. So that could be the reason why the locks are not visible in sm12, but still complains of having locks on characteric ZCUSTNUM>
Any suggestions appreciated.
Thanks,
BWer
Message was edited by: BWer
Message was edited by: BWer
Hi,
In SM12, did you also remove your User ID and then check for locks...
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
You have to close the cancelled change run before starting data loads for master data infoObjects that were included in the failed change run. This is done by running the change run again for your infoObjects. You can do this by using transaction RSATTR, select the infoObjects and execute the change run. Once the change run is completed successfully, you should be able to do your data load with no problems.
Also, you may want to check table RSDDAGGRMODSTATE to see if you have any change run job that are still open.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.