04-01-2009 2:35 PM
Hi,
I have an interval meter register, which i have mapped in EDM as a profile. But the consumption getting recorded in the profile is not getting adjusted based on the CT/PT attached to that device.
How can the CT/PT ratio along with the meter ratio can be included to the consumption recorded in profile.
Thanks in advance
04-02-2009 6:15 AM
Hi,
Meters have Billable meter multipliers derived from meter and CT/PT ratios. For scaling purposes, CT/PT ratios are stored at Device level for Non Interval Meters.
For Interval Meters, consider to apply CT/PT multipliers before importing the interval data into SAP..In this case, the rate data for Interval Meters correposponding to RTP rate will ignore the CT/PT factor during the billing run.
Hope this helps..
Thanks
Vinod
04-02-2009 6:15 AM
Hi,
Meters have Billable meter multipliers derived from meter and CT/PT ratios. For scaling purposes, CT/PT ratios are stored at Device level for Non Interval Meters.
For Interval Meters, consider to apply CT/PT multipliers before importing the interval data into SAP..In this case, the rate data for Interval Meters correposponding to RTP rate will ignore the CT/PT factor during the billing run.
Hope this helps..
Thanks
Vinod
05-20-2009 11:28 AM