Post Exit Method enhancement in Web dynpro not getting triggered in Quality

[mayank_agarwal7]

Hi All,

I have created an Post Exit method enhancement in the standard Web Dynpro.

This enhancement is working good in Development system. But when I transport this enhancement to Quality then the enhancement is not getting triggered.

What could be the possible reason for the same?

Thanks & Regards,

Mayank Agarwal

[thomas_jung]

Make sure that the enhancement itself is active. Also do you have this enhancement tied to a Switch? If so, make sure the Switch status is set to active.

If everything shows active, but the enhancement doesn't fire, then you should open a support ticket.

[mayank_agarwal7]

Thanks Thomas for your reply.

I checked the enhancement. It is Active in both Development as well as Quality.

However I am not aware of Switch tied to Enhancement.

Can you please tell me how can I check whether a switch is tied with it or not?

Also please let me know the way to check its status.

Thanks & Regards,

Mayank Agarwal

[thomas_jung]

If you created the enhancement, then you would likely know if there was a switch. You would have had to create a custom switch and business function set and assign it to the customer package that you place the enhancement development within.

[mayank_agarwal7]

Thanks Thomas.

In that case I dont think that the enhancement is associated with the switch.

I will them open up a support ticket.

I'll consider this question as answered.

Thanks & Regards,

Mayank