no interfaces listed for ECC Business System in PI 7.1 for intrf. Detrm

[Former Member]

Hi all,

I have come across this situation earlier, did some settings in SLD ..tech system...(Don rembr it nw....)

I am not able to see the list of interfaces for an ECC Bus.System during Interface determination,

I manually have to key in the name of the BAPI instead of the values appearing in the value list....

I am sure that the is something missing while havin created the BS and TS in the SLD,

Can someone guide me what my approach would be.

Replies much appreciated. Thanks

[former_member181962 · Accepted solution]

I am sorry. Please ignore my previous msg.

In SLD, you create a BS for a Technical system and a Software Component Version under a Product.

You have to add the Product to the the Technical system , then only you can see the interfaces in serach helps.

Edited by: Ravi Kanth Talagana on Mar 25, 2009 5:23 PM

[Former Member · Accepted solution]

yes..ths exactly is my approach,

still doesn't work..

thanks though

[Former Member · Accepted solution]

let me explain:

TS: RD1_001

BS: RD1_001

Product: ECC 6.0 (fr example...)

then What shd the SWC's be? ne suggestions?

once this is set i have to add the product under TS rite...and select the above SWC's rite??

[former_member184619]

Hi,

If you are using a standard BAPI then it will not be visible under your business System, instead you have to select all while choosing the BAPI.

If other components including ZBAPI are not visible then follow these steps:

1. Create a product

2. Create a software component (Use this in IR)

3. Create a technical system (assign the above product to this)

4. create a business system (Use this business system in ID)

In IR import the BAPI/ZBAPI under the baove defined software component.

Sachin

[Former Member]

thank you every1

[former_member181955]

Hi

Please assign the software component(Product) in which you have imported your BAPI in IR to your

Business System in SLD.

Then you can see all the interfaces of that software component in your Business System(ECC) in ID.

So just add the software component to your Business System in SLD then you can get the interface in

ID.

Check the following link for the same issue.

Thanks

Prasad Nemalikanti

[Former Member]

any inputs??

[former_member181962]

After you import your Business System in the ID, I think you can add the Inbound Interface names and the outbound interface names in two separate tabs in the Business System.\Then those interfaces will appear in the search help.

Regards,

ravi