how to change the Status CRTD of the Inspection Lot?

[Former Member]

Dear all.

I want to Complete an Inspection Lot 10000000005 In the T-CODE qvm2.When I select the Inspection Lot 10000000005 and press F8 to Complete the Inspection,the SAP show an error message "Status check error".

And the detail info show that the error was cause by the Status CRTD of the Inspection Lot.I check the Status of the Inspection Lot 10000000005 and found that it's Status was CRTD CHCR SPRQ.My question was how to change the Status CRTD of the Inspection Lot?

Regard

Yoda

[Former Member · Accepted solution]

Hi

CRTD means ...

In material master QM vew-inspection setup->Inspect with task list tick is there.

Now to change status,

Go to Qp01>create a task list for material(If not exists)>remember date of creation of task list must be prior to date to creation of inspec lot

If task list is created/exists>go to QA02.<inspection specification -->click on Inspec Spec

and attach task list

go to sample tab....click on sample.

Now save it.

Status will change to REL

Regards

Sujit