on 03-16-2009 11:54 AM
Hi,
SAP Gurus,
I have maintain following setting
Material master -
QM View -
Inspection setup----
Inspection type 01 & 08 Active with Tick mark on Post to inspection stock & Tick on automatic UD.
Process: STOu2026..Deliveryu2026.PGIu2026u2026u2026GR through MIGO (Goods received against Outbound delivery)
Here I am facing problem: My requirement is "as QM view is maintain" The system should propose GR in quality (instead of Unrestricted ) But it is not happening System propose unrestricted only
Plz help
Best Regards,
Parag Save
Dear Parag,
Do you have any userexit been used while doing MIGO. please check with MM for the same. IF so please take the help of ABAP and check with debugging.I have faced this issue earlier.
Regards
Gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Closed
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI Parag,
Check
1) Have U maintained the Q info record for this material vendor combination ? In the inspection control tab no inspection so that is the reason.
2)I think U have not maintain DMR
With regards
Yashodhan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Parag
please let me know what is the movement type you are using for the STO. Please try activating 05 inspection type also. It might work
Regards
Gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Parag,
Check - during GR in "where" tab in your case stock type would be "unrestricted use" but it should be "Quality inspection".
Hope it would help you.
Thanks!!!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
parag
I case of STO when outbound delivery happens it create 08 inspection lot at receving plant.( Say you have craeted STO for moving material from X plant to Y)
kindly check for receving plant Y wheather yuo have maintained 08 inspection type and not 01.
Try this
regards
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Parag,
Make sure that you had maintained the inspection setup before the STO was made.
Also please let me know the movement type you are using for the stock transfer
Regards
Gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.