cancel
Showing results for 
Search instead for 
Did you mean: 

Removing and Adding Transports to a Maintenance Cycle

Former Member
0 Kudos

Good Day;

I think I have figured out how to move transport requests in and out of maintenance cycles. Below is the process I used.

If anyone has more information on this, please let me know.

Removing and Adding Transports to a Maintenance Cycle

Removing a transport from a maintenance cycle

Prerequisites

Transport must be in Modifiable status

Must be owner of the transport

With in the u201Ccorrectionu201D, click on u201Caction buttonu201D

Select u201CLog on to systemu201D. This will take you directly to the development system.

Use T-Code u201CSE10u201D

Locate the transport under the assigned project.

To the top toolbar, click on Utilities

Select u201CReorganizeu201D

Select u201CDelete Project Assignmentu201D

You have now removed the transport from the assigned project

Adding transports to a maintenance cycle

Prerequisites

Transport must be in modifiable status.

Must be the owner of the transports

Using u201CSolar_Project_Adminu201D

Select the maintenance cycle you want add the transport to

Under the development system Status Switches do the following;

Request can not be created:

Click on the pencil and select yes. This will change the setting to; Requests can be created.

Request cannot be released:

Click on the pencil and select u201Cyesu201D. This will change the setting to; Request can be released.

Log into the development system.

Use T_Code SE10

Select your transport

On the top toolbar, click on utilities

Select u201CReorganizeu201D

Select u201CAssign to Projectu201D

Select the project you want to assign the transport to.

NOTE: Transports that have been added to a maintenance cycle can not be released through CHaRM. These transports need to be released manually via SE10 in the development system

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi Don,

not sure on this but you may try to add attribute:

SAP_TMWFLOW = <name of maintenance cylce> to your transport in SE10. Maybe you are able to release it via ChaRM then.

Still I am not sure where the link to the change document would come from.

Probably it is just not intended to add or remove transprot requests to or from ChaRM.

Regards

Former Member
0 Kudos

Thanks Christian

That's the one problem with this process. If you move a transport into a maintenance cycle you can not associate it with a correction. That is why it needs to be released manually.

Regards

Don Newton

Former Member
0 Kudos

take a look at Kriti's response in this post (7th one down). It shows you how you can add a transport to a correction so it can be part of the ChaRM process rather than just adding it to the task list.

Answers (0)