on 03-05-2009 3:47 AM
Dear All,
I have created inspection plan. During manual creation of inspection lot , when I press tasl list / spec. tab(to assign inspection plan) , an error comes that no inspection plan found . What may be the reason ?
Regards,
Hi,
Pl. check following -
1) Validity period of the Inspection plant. - Atleast 1 day before start of Inspection Lot
2) Release Status of Inspection Plan. - Inspection Plan must be released
3) Usage of Inspection Lot - Must be same as that of Inspection Lot
Regards,
Prashant
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Pl check whether the insp plan usage maintined in insp plan header belongs to the insp type in use and the same inspection type is maintained in Material master
Regards
Venugopal
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Rohit
The key date in the QP01- inspection plan creation should be before the date in which the inspection lot is created. If you have made a manual inspection lot and afterwards create the inspection plan at a later date this problem normally occurs.
regards
Selva
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.