Validation Rule for the coding mask and project profile

[Former Member]

Hi,

I have two project profile and two coding masks. I want one project profile to be only used by defined coding mask for that profile.

So i have maintained a validation rule as follow -

Prerequisite - Project Def. :1-3: = 'A5M'

Check - Project Profile = 'ABC'

And if the above check is failed then give me an error message.

Now i am trying to add the project profile other than 'ABC' for the coding mask starting with 'A5M', but still the system is not giving me an error message configured and allowing me to save the project.

Is there any other thing which is tobe activated other than assigning the validation rule in project profile and clicking the Autom. validation check box in OPSA.

Request to confirm share the views.

Thanks

[prabu_kaliappan · Accepted solution]

Hi,

Try the following, this must work.

Prerequisite

PROJ-PROFL = "ABC"

Check

PROJ-PSPID: 1-3: = "A5M"

Message

Project profile & Coding mask wronly assigned

Repeat the same for other project profiles also.

Enter this validation in your project profile. Check in "Auto Validation"

In transactinal data,

Enter project def and select the wrong profile. when you save the project system will show you the error message.

Hope this will help you.

Regards

Prabu

[Former Member]

Check the "Auto Validation' in project Profile. Otherwise u have to trigger the validation manually in Project Builder (Cj20N-Edit-Validation/Substitution-Valdation)