How to know MI Configuration is there in my server...

sankar_narayana · ‎03-03-2009

How can i know weather MI Configuration is done in my server or not. How to start MI Administration Webconsole.

Helpful answer is highly appreciated.

sankar_narayana · ‎04-06-2009

My problem is resolved.I have done template configuration in my MI Server

Former Member · ‎03-03-2009

Dear Sankar,

Thsi should have been posted to the Mobile or NetWeaver Administrator Forums, but anyways, you are lucky since I saw this on my news feed.

Ok here it goes. There are different ways to check whether MI is installed.

1.Simplest would be to ask your BASIS Administrator.

2. If you are currently on SAP NetWeaver 7.0 SP09 and above you can check the usage types installed by using this relatively for your server:

Possibility 1:

If you find MI activated and configured, you can launch your NetWeaver Mobile Administrator using

http://<host>:<http_port>/nwa - then navigate to Administration-> Mobile Infrastructure.

Possibility 2:

MI is not there, you need to install additional usage type:

Refer note: 883948

or

<a href="http://help.sap.com/saphelp_nw70/helpdata/EN/45/ff1a64cbb709eee10000000a1553f6/frameset.htm">Installing an Additional Usage Type</a>

or

3. If you are an MI beginner:

Learn about MI and MI development from NWDS-> Help Contents -> NW Dev Studio Doc->Mobile / MDK

Central Help links for NW Mobile 7.0 / MI:

Hope this solves your question.

Regards,

Veera

Former Member · ‎03-03-2009

Plz see the below thread for help

How to know MI Configuration is there in my server?