on 02-18-2009 2:57 PM
Hi guys,
After approving SC, wf-batch creates PO automatically. How I can debug wf-batch?
Hi ,
You will not be able to debug SC after approval. A better approach would be to put the SC on hold and run FM- bbp_reqreq_transfer in debugging mode.
Regards,
Sanjeev
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
For which user have I set breakpoint in the desired FM?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
The PO is creating. My problem is to check how the table bbp_pdpset is filled. In TX ST05 I can see that there is a insert of the data in table bbp_pdpset in FM ''. But if put break point in this FM, the program doesn't stop there.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi ,
I have ran FM-bbp_reqreq_transfer in debugging for the SC on hold, but PO wasn't created. And also there were not any error messages.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Evgeny,
I am not sure what exactly you ment by debugginf wf-batch.
But for general workflow debugging tips please refer the below link:
http://www.sap-img.com/workflow/workflow-debugging.htm
Hope this helps!
Regards,
Saumya
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.