on 02-18-2009 7:39 AM
Hi everybody,
i have a Problem with EWAs. It seems to work all fine, it does, until the EWA is in the state "data is available".I can generate a EWA without a problem, when i use the button "start service processing", but i want it to be generated automatically. I searched with TA SM37 for the job SM:EXEC SERVICES in SolMan and in the monitored system, but i didn´t find the job?
Any ideas, what the problem can be?
Best regards,
Stefan
Hello Stefan,
Please have a look at the following blog and see if ur config is set up correctly
/people/federico.babelis2/blog/2006/04/23/sdcc--service-data-control-center-configuration-guide-for-dummies
Also refer to note 986973,it can be useful
Let me know if this helps
Rohit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
@Rohit
Thank you for your reply, but this was not what i looked for. Thank you anyway!
@David
Thanks, i will check my system and look at the table, i think this is a good beginning. Unfortuneately the note is at the moment not available....
I am going to give feedback, if i found the finally solution!
Bg,
Stefan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Stefan,
SM: EXEC SERVICES should run regularly in the Solution Manager.
It's triggered by SM: SCHEDULER and the settings in table DSWPJOB.
Note 529108 should help you specifically with these two jobs.
best regards,
-David.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.