BPM Ativation error

[Former Member]

Hi all

Whenever we create a bpm we have to go sxi_cache and activate the bpm ourself even though the return code is 0 it work fine then but if you go and change the bpm and active and then reverse the change so that the bpm is the same as it origanaly was and activate it, it does'nt work anymore you have the recreate the whole bpm again.

Any help will be appreciated.

Regards

[Former Member]

Hi

Thx for the help work fine again.

regards

[SudhirT]

Hi,

Delete the old instances in SWWL and reimport the BPM to ID as suggested then it should work.

[VijayKonam]

Check if the HMI_DIRECTORY RFC destination is working properly. This usually happens because of the cache refreshing problems.

VJ

[prateek]

Whenever we create a bpm we have to go sxi_cache and activate the bpm ourself

Not mandatory.

it does'nt work anymore you have the recreate the whole bpm again

I dont think that recreating the BPM is required. Once you changed it, have you reimported it into ID?

Regards,

Prateek