on 02-16-2009 3:13 AM
Dear all
here is a question.
please give me some advice.
when i set TECO from the project definition, all the WBSE and activities are TECO.
but when i want to undo TECO, i have to undo the WBSE and activities one by one.
it is time-wasting.
could you tell me is it a simple way to undo TECO at once for all the WBSE and activities??
thanks a lot
Judy
You go to planning board by selecting project defination and expanding it. Then click on all select and Edit -- status -- undo TECO
Sudhir
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
you can achieve the same via.... Undo Teco for any of the higher level for ex. say Level 1 WBS element.... and the TECO will be undo for all the below PS Objects to that WBS. ( Activities, WBS exc. )
Just check .This is based on System status pass on logic for the lower level WBS.
You do this from any of Project change txn Project Builder ( Cj20n) , Project planning board. etc.
you can do Undo teco at any level of WBS , if you does for the P.D. It will does undo for all the PS objects.
Regards
Nitin
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
14 | |
10 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.