Installation

[Former Member]

Hi,

Can use explain the below control parameters of Installtion/replacement/removal.

1.TEMPAEINST-Propose temperature area from installation

2.LASTMETERI-Info-last device of installtion will be removed.

Where it reflects in the transaction.

Thanks

Oven

[oliviawalsh · Accepted solution]

Hello,

I hope the following is useful:

TEMPAEINST (Propose temperature area from the installation)

During full installation, the temperature area is proposed from the installation. If the temperature area in

the installation has not been specified, the default value from the regional structure is used.

LASTMETERI (information; last metering device of installation is being removed)

When the last metering device of an installation is removed during full removal or technical removal,

and a customer exists for this installation (valid contract), an information message is displayed for the user.

Regards

Olivia

[Former Member]

Hi Olivia,

TEMPAEINST (Propose temperature area from the installation)

During full installation, the temperature area is proposed from the installation. Can u please expailn this in detail.

If the temperature area in the installation has not been specified, the default value from the regional structure is used.Can u please explain where we maintain the temperature area in the regional structure.

Thanks