Early Watch Alert problem with not create EWA session in SDCCN

[Former Member]

Hi all

I am setting up EWA.

I done basic configuraition through SPRO in solman.

I activate EWA in operation setup and then I set up SDCCN in SMSY --> Environment --> Solution manager Operation --> Administration SDCCN.

I can find Service Preparation Check and Maintenance Package so I create new task Refersh session.

Refresh session task finished but not create EWA session.

I checked two RFC destinations. that is OK.

RTCCTOOL is all green in solman.

my system is solman 4.0 SP14

st-pi 2008_1_700

st-api 01L_CRM570

st-ser 700_2008_1 lv 3

how can I create EWA session

any help

thanks

[Former Member]

Hi,

1 The first you should check your SYSTEM NAME in transaction SMSY. you can checked assigned RFC destination in SMSY.

2 The problem was that the service definitions had been deleted on both systems but were not replaced. this meant that Solman could not create correctly EWA sessions and satellite systems could not understand correctly that EWA had benn create. pls see note 727998. this note can help you.

[Former Member]

Hello,

Here are the steps for EWA generation on SolMan.

1. Ensure you have /nsmsy configured for the satellite system concerned in solution manager.

2. Ensure you have generated the _BACK connection from solution manager so that it exists in the satellite system.

3. Ensure /sdccn is configured in the satellite system.

4. Create a logical component for the system in solman.

5. In /ndswp, create a solution for the EWA.

6. Link the logical component into the Solution just created.

7. Define the EWA execution time.

8. On the satellite system, execute sdccn and run the maintenance job.

This should pull the EWA session into the satellite system, then either give it time or run it now.

Always a bit fiddly to start with, but you'll soon get the hang of it.

Cheers.

[raguraman_c]

Hi,

Check [this SIM file|https://websmp202.sap-ag.de/~sapidb/011000358700006936042005E.sim] file.

In step 19 of this sim file you can see Session, if you don't get that in your system, click on create service button.

This should solve your problem.

Feel free to revert back.

-=-Ragu

[Former Member]

hi

thanks for u r reply.

but I cant open sim file.

how can I do?

[Former Member]

Hi,

You can check those sim files in [https://websmp202.sap-ag.de/rkt-solman] --> Technology consultant and system administration ---> EWA

Regards

Naveen

[raguraman_c]

Hi,

You need to install SAP TUTOR.

Can be downloaded from

https://websmp130.sap-ag.de/sap/bc/bsp/spn/download_basket/download.htm?objid=0120025231000102316620...

Hope this solves your problem.

Feel free to revert back.

-=-Ragu

[Former Member]

hi Raguraman

I saw your sim file. thaks

but I can see EWA seesion in DSWP

My problem is not created EWA session in SDCCN on satelite system.

thanks again

[Former Member]

Hi

Are you getting the "red flags" from the early watch report?

You would probably need to start the job scheduler again. you need to doing the following which may help you.

The 'Task Processor' background job, which collects the session data, has been changed ... restart the process.