All bounds exceeded without finding valid load using TLB profile -Error TLB

[Former Member]

Hi All,

When I am running TLB I am getting this error.

Current system that I am working on is SCM 5.0 with service pack 13. When I add some operator to the lower limit of TLB profile then it is working fine but when I keep it empty then it is giving such error.

Can any one help me out on this issue.

Thanks and Regards

Jignesh

[Former Member · Accepted solution]

Hi Jignesh,

The error you describe is standard SAP.

I believe in the TLB profile, you have selected one of the following Relationship Rules

1 Connect Upper Limits with "AND", Lower Limits with "OR"

2 Connect Upper Limits with "AND", Lower Limits with "AND"

3 Relationship is Specified by Customer

If you have selected either 1 or 2 rule in the TLB profile

You would have to mention LL( Lower limit) and UL( upper Limit) and a parameter value.

Since you are not maintaining any Limits, it is giving you the error when running TLB run

What is your exact requirement?

Regards

Kumar

[Former Member · Accepted solution]

Hi Kumar,

Thanks for the reply. My question is with Upgadation of patch level 13 we have issue in TLB.

The lowe limit is maintained but there is no operator assigned to lower limit. This field is left blank. It was working fine earlier. But after upgading patch it is throwing such errors. If I fill the operator field with some values for eg. ">=" then it is working fine.

Thanks and Regards

Jignesh