on 02-04-2009 6:56 PM
hi all,
I have a few questions about SOLMAN_SETUP for any of you with EHP1 experience.
What do you do if you have done some of the steps in the guided procedure? Just skip the step or redo the step witha new user and delete the old user?
Do you have to perform it both in Dev and Prod?
Any of cool tidbits learned so far?
regards,
Jason
Not sure about the Dev and PRD we only did it in DEV. I just saw a install doc for Solman with EHP it just came out so when we are ready we will apply it together
MM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Jason
We just did the EHP this is what you are referring too right? When we ran the solman_setup we had diagnostic errors if you checked everything and it still doesnt go away you can set the status to manual and it goes green also you can redo the setup at any point just hit continue past the steps you already performed. Hope this helps
Mike
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
83 | |
24 | |
12 | |
9 | |
7 | |
6 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.