Error showing while genrating partner Profile form ECC to SRM

[Former Member]

Hi

I have did ALE setting bet SRM and ECC system. I have Created Distribution Model and generated partner profile Form SRM it working fine. The Distribution model is created in ECC.While when i try to generate partner profile for same model form CC its show ERROR.

Inbound parameters for message type MBGMCR could not be created

Enter a valid process code.

Plz rely its argent.

[Former Member]

hi DEAR ALL

I HAVE SOLVE THIS PROBLEM.

i HAVE CREATED ZXXX

PROCESS CODE I HAVE ATTACHED IT TO PARTNER.

THANKS FOR U R SUPORT

[Former Member]

Hello Sharad,

Please check note, might be helpful.

Note 330401 - Process code does not exist f. BBPCO01, BBPIV01

Thanks

Ashutosh

[former_member206968]

Hi

You can try creating partner profile manually using txn-WE20. When assigning idoc type MBGMCR, you would know the exact error causing this problem.

Regards,

Sanjeev

[Former Member]

Hi Thanks for reply.......

Actually i Have distributed the Model form Srm AND it generate Child model in ECC.genration of partner profile working fine.but wen i want to generate partner profile form ECC it show the above error.

I have maintained Outbound message in SRM

ACC_GOODS_MOV

MBGMCR

SYNCH.

When i genrate partner profile form ECC its show above error

in bound parameter

ACC_GOODS_ BAPI

Inbound parameters created for message type ACC_GOODS_MOVEMENT

MBGMCR BAPI

Inbound parameters created for message type MBGMCR

MBGMCR

Inbound parameters for message type MBGMCR could not be created

Enter a valid process code

[Former Member]

Hi Sharad,

Its enough if you generate the partner profile & Distribute the Model once from SRM.

You don't have to do repeat it again in ECC.

Cheers,

Akash.

[Former Member]

thanks

But In book for SRm config setting it mention that need to genrate partner profile form ECC.

I am not distributing the model form ECC. just need to genrate partner profile.

Thanks.

[Former Member]

Hi,

Can you check in WE20 in ECC for SRM (Partner Type LS) whether the Message Types have been created (in Inbound parameters) with the Processing code. Normally, this is automatically created by the system. For MBGMCR, the processing code should be BAPI. If it is successfully created, you don't need to worry. You can rest assured that the Document will flow from SRM to ECC.

Cheers,

Akash