QUALITY SCORE

[Former Member]

Can anybody explain me what is the pupose of Quality Score in QM Module

AYK

[former_member186399]

Dear AYK

Dear raja,

Quality score are maintained for quantitative valuation of the quality of inspection lots.

1) They have to be first maintained in the client level setting

SPRO > QM> Maintain settings at client level> You need to maintain the highest quality score (100) and lowest quality score (1) system doesnt take 0. also Lower limit for good quality (90)

2) it is maiinly used in the selected sets for usage decision

QS51/ 03 catalogs for each UD code you can give a Quality score. So while you are giving UD system picks up this score and update the same for inspection lot , material, vendor, customer as applicable.

You can give 100 as quality score for clean acceptance, 1 for complete rejection, may be 50 for partial acceptance etc.

You can check for the reports in the information system.MCXE, MCVE, MCOE

3) There are different quality score adoption procedure ( defined by SAP)

SPRO > QM>Quality Inspection > inspection lot completion >Define quality score procedure

Share of scrap in lot

Maximum share of scrap for chars

Minimum quality score for chars

Weighted from share of scrap for chars

Weighted from quality score of chars.

From usage decision code

You can choose anyone and can be customised for inspection types these is done in

SPRO > QM>Quality Inspection > inspection lot Creation > Default values for inspection types> anyinspection type > inspection lot completion tab > Quality score procedure.

4) If you want to use quality score procedures that access the weighted shares of defects for the characteristics, you must maintain the characteristic weights.

SPRO > QM>quality Planning >Basic data> Inspection characteristic > define characteristic weighing > weight factor

If you want to use quality score procedures that access the quality score of the characteristics, you must maintain the defect classes.

SPRO > QM>quality Planning >Basic data>Catalog> Define defect class

If you want to use quality score procedures, in which the system calculates the share of scrap, you must:For this a) scrap share have been defined in Customizing .b)Assign suitable procedures for estimating the scrap share to the characteristics in the task list c)Identify inspection characteristics as relevant for scrap in their control indicators.

hope this helps

Regards

gajesh

[Former Member]

thanks

AYK