Error in ECC6.0 - Dunning Proposal - FPVA

[Former Member]

Hi SAP Expert

I had executed Dunning Proposal - FPVA. I was hit the error message from system said "There are no internal numbers which have not been assigned".

I go into SNUM but I couldn't find the number range object for Dunning Proposal. May I know where I can define for internal numbers in order to execute the Dunning Proposal - FPVA? Which object I should refer to ?

Million thanks.

Regards

Jacky

[Former Member]

Hi:

Please check, whether dunning procedure is defined or not. It seems some problems in dunning procedure only.

Regards

Shashi

[Former Member · Accepted solution]

Jacky,

Go through the SAP note 732878.

You need to maintain number ranges in SNUM for object id EMMA_RUNID.

The above config is for all mass programs in FICA i.e FPVA, FPVB, FPY1, FPMA etc

Hope this helps

Rgds

Rajendra