E2E_EXTRACTOR_CONTROLLER jobs don't run with SOLMAN EhP1

[Former Member]

Hi!

I am using SAP Solution Manager 7.0 EhP1 and would like to use Solutio Manager Diagnostics functions there.

I already installed Wily Introscope 8.0, the SMD agent. I configured all the satellite system and can already see some graphics and BI data within Workload Analysis, Change Analysis.

My problem is that since almost one month no E2E_EXTRACTOR_CONTROLLER jobs

are scheduled in SOLMAN.

Question:

Can some one explain how to schedule these jobs in order to see actual data for WA, CA, etc.?

What I already done:

I run several times again the SMD Setup for Managing and Managed system without any errors

I traced the entries in table E2E_ACTIVEEXTR (set for all the entries the "x" flag in field "Active")

I have a look int the table E2E_ACTIVE_WLI. This table is not empty and contains a lot of entries.

I have a look int the table E2E_ECSTATUS . This table is not empty and contains a lot of entries.

It will be great to get some helpful information

Thank you very much

[mkloeffer]

Hi Holger,

with EhP1 the Extractor Framework has been changed, there is a new job "EFWK Resource Manager" which takes care of the ressources used for data extraction. You can use the "Extractor Framework Administration" in the Root Cause Analysis Workcenter to check if the extractors are running.

More information can be found in the Workload Analysis User Guide for EhP1 under:

http://service.sap.com/diagnostics --> User Guides --> Workload Analysis.

Best regards

Michael

[Former Member]

Hi!

Many thanks for your reply.

With "Extractor Framework Administration" within SOLMAN_WORKCENTER you mean the site:

http://full host name:8000/sap/bc/webdynpro/sap/wd_efwk_adminui_config

When I call this page the Time out exeption comes up.

You spoke from

> a new job "EFWK Resource Manager" which which takes care of the ressources used for data extraction.

How can I track whether or not this job will be scheduled correctly?

Thank you!

[mkloeffer]

Hi Holger,

this job should be scheduled every minute, the "EFWK Cockpit" will give you the information by system and access to the logs.

The timeout is probably because the WebDynpro application is compiled when you call it the first time. May try it again and check in sm50 if it is still compiling.

Best regards

Michael

Edited by: Michael Kloeffer on Feb 10, 2009 6:12 PM

[raguraman_c]

Hi,

I am assuming that your BI Setup step in SMD wizard is successful without warning or error.

Please analyze the SMD application log and SMD System log. This can be found under,

http://<host>:<port>/smd --> diagnostics administration --> Managed systems --> Agent Logs.

Also upload these logs to filesharing sites and share the link. So that I can check the log files.

Feel free to revert back.

-=-Ragu

[Former Member]

Hi!

Many thanks for your response.

Unfortunately when I access to

http://<host>:<port>/smd I can see only Diagnostic Setup tab.

Question:

Do you know whether with EhP1 the Extractor jobs are also calling "E2E_EXTRACTOR_CONTROLLER"?

How can I manually schedule these jobs?

Thank you very much!

regards

Holger