Warning message during sales order creation

[bhushan_bivalkar]

When I create sales order sytem gives me following message. Please guide me

Reorder point for item 000010 has been exceeded: 1 STR

Message no. V1108

Diagnosis

You have entered an unusually large quantity in item 000010.

Materials management agreed on a reorder point for this material. Only after this quantity is exceeded, procurement for the material is initiated.

Since the schedule line quantity exceeds the reorder point, it is

possible that there is not enough stock at the time of delivery.

Procedure

Check whether you have entered the right quantity and whether the unit of measure is correct.

Inform the materials management department about the large order quantity in item 000010, to ensure that the quantity entered for the item can be delivered.

[Former Member · Accepted solution]

Hi,

The message occurred as you have maintained the Reorder Point in MRP1 of the material master.If the sales order quantity exceeds the quantity maintained here, the system will give a warning, stating that the reorder point is exceeded.

Regards

Vamsi Javaji

[skrishen9]

Hi Bhusan

With reference to your query I think the MRP is being activated in both at plant level

as well as at Storage Location level. Go to MRP1 and MRP4 and check the reorder

quantity mentioned in these tabs. Bcoz of this only you are getting the message here.

I hope this will solve your query.

thanks

Sushant

[bhushan_bivalkar]

Yes I am fully agree with you and I have done so but I didnt understand the message meaning . Although its a warning message but it seems some confusing

[Former Member]

Hi Bhushan,

Just go to MM02 and put your material and then go to sales org 1 tab.

Over there just check out min. order qty.

If you have maintain some value over there then request you to remove that if not required.

Other wise make the order greater than that quantity.

If still problem exist then let us know

Regards

Raj.