RFC call failed: JCO.Server could not find server function 'SET_SLD_DATA'

[Former Member]

hello Gurus

we are configuring the connection to SLD (J2EE) from our SAP ECC 6.0 Abap, in Tx RZ70 when we start the data collector the followin error appear:

SLD DS Start Program

0: conexcel_DQA_00 : Execute program: SLDMSGSRV

0: conexcel_DQA_00 : Execute program: SLDLIVECACHE

0: conexcel_DQA_00 : Execute program: SLDIPSERV

0: conexcel_DQA_00 : Execute program: SLDINSTSP

0: conexcel_DQA_00 : Execute program: SLDINSTSC

0: conexcel_DQA_00 : Execute program: SLDINSTPRD

0: conexcel_DQA_00 : Execute program: SLDGWSRV

0: conexcel_DQA_00 : Execute program: SLDDBSYS

0: conexcel_DQA_00 : Execute program: SLDCOMPSYS

0: conexcel_DQA_00 : Execute program: SLDCLIENT

0: conexcel_DQA_00 : Execute program: SLDBCSYS

0: conexcel_DQA_00 : Execute program: SLDAPPL_SERV

0: conexcel_DQA_00 : Collection of SLD data finished

0: conexcel_DQA_00 : Data collected successfully

0: conexcel_DQA_00 : RFC data prepared

0: conexcel_DQA_00 : Used RFC destination: SLD_UC

0: conexcel_DQA_00 : RFC call failed: JCO.Server could not find server function 'SET_SLD_DATA'

0: conexcel_DQA_00 : Test mode: No batch job created

the RFC SLD_UC works correctly.

Please your Help

Thanks

HEPC

[Former Member]

Hai,

Check the below link.....

Regards,

Yoganand.V

[Former Member]

Hello Yoganand,

according to the link:

I had the same problem. The way I fixed it was to make sure the SLD_UC and SLD_NUC are NOT defined anywhere in the VA. These two processes are created implicitly and should not be defined. Remove them from anywhere they appear in the VA, and recycle the gateway. You should then see that each program is registered twice in the SLD gateway and RZ70 should work.

if we remove the connections SLD_UC and SLD_NUC in the VA,the connection test for RFC's SLD_UC and SLD_NUC not work, we don't understand meant "and recycle the gateway".

Thanks