0 Communication IDOCS

[Former Member]

Dear XI experts,

I have setup a distribution model with the message type MATMAS and setup the partner profile to send IDOC from SAP to XI. I get this message below

Model view SCBIT40 has not been updated

Reason: the following ALE connection already exists in model view SCBIT01

..... message type MATMAS

..... sender M2ECLNT800

..... receiver M2ECLNT001

When I try to send the material through transaction BD10 it gives me a message

0 communication IDoc(s) generated for message

MATMAS

Thanks for your analysis.

Br,

[MichalKrawczyk · Accepted solution]

hi,

1. do you have MATMAS IDOC specified for M2ECLNT001 logical system in WE20? yes/no ?

2. do you have logical system M2ECLNT800 assigned to your client?

(in transaction SALE) ? yes/no

check those two things and change them as I'm sure they are not set properly

and your matmas will work

Regards,

Michal KRawczyk

http://mypigenie.com XI/PI FAQ

[Former Member · Accepted solution]

hello,

1. do you have MATMAS IDOC specified for M2ECLNT001 (PI system)logical system in WE20? yes

2. do you have logical system M2ECLNT800 (SAP) assigned to your client?

(in transaction SALE) ? no instead I see another logical system name T90CLNT090 which is assigned insstead of M2ECLNT800.

I guess that can be issue here.

[MichalKrawczyk · Accepted solution]

hi,

then you have two choices:

a) create a new distribution model:

from T90CLNT090

to M2ECLNT001

b) change the assignment of client from T90CLNT090

to M2ECLNT800

then it will work

Regards,

Michal KRawczyk

http://mypigenie.com XI/PI FAQ

[Former Member · Accepted solution]

Thank.. you..

[Former Member · Accepted solution]

Hi,

I had one distribution model and I deleted it. I´ve created a new one using the same logical client and the same message type but when i go to ditribute I obtain this error :

Model view TEST_01 has not been updated

Reason: the following ALE connection already exists in model view PA/OM

..... message type HRMD_A

..... sender HRMCLNT400

..... receiver HRECLNT500

I´ve read your post,, could you explain mehow I can the client assigment?

thnaks a lot and best regards, Sapera