question about transport system configure

[Former Member]

I have two system dev & prd, the prd is domain controller, the router is from dev to prd.

I want to delete all transport configure and reconfigure it. Now I login to prd 000, and delete dev from transport system, and use se06 to initial the stms, then I go to stms, the configure has been initialized.

But when I login dev000, the two systems configuration and the transport router is still exist in stms and I can not use se06 to inital it. I am sure that in prd 000, the configuration has been deleted succussfully.

the configuration is still exists in dev000, and I can not do any operation from dev000 which is not domain controller, and the real control prd000 has been delete by me.

I try to use se06 , but after reinstall cts, I can still see the configuration in stms.

Could you give some solutions , Is there any problem with my operation?

thanks a lot.

Edited by: victor on Jan 11, 2009 9:17 AM

Edited by: victor on Jan 11, 2009 11:07 AM

[Former Member]

oh, just there is a menu: system overview->extras->delete tms configuration. That can delete the configuration. what a pity,, I did not found that menu before,

But exactly, I can not delete the configuration by se06.

thanks for you help.

[former_member186775]

Hello Victor,

you said PRD is the domain controller and successfully you

deleted previous configuration in PRD ,now login into DEV and

in the same delete the cofiguration in DEV too.when everything

is cleared you start from the first and start adding DEV to the

domain PRD.hope this helps.

regards,

Manjula.