Regarding non-unicode to unicode conversion in mapping

[Former Member]

In our project we have Pi system which is installed as unicode system.

But the SAP systems at the sender side is unicode and most of them are non-unicode systems.

We have a doubt regarding the challenges that we need to face in PI mapping with reference to unicode and non unicode conversion.

Is it possible for us to Map the RFCs of non-unicode SAP system at sender side with the help of graphical mapping?

Any conversion we need to do?

Thanks & Regards,

sasi

Edited by: sasitharan on Jan 6, 2009 4:25 PM

[Former Member · Accepted solution]

Hi

NO conversion is required to map unicode to a non unicode system. Only while setting up RFC destinations for proxy etc to unicode or non unicode system you need to select or deselect the option.

Thanks

Gaurav

[Former Member]

Thanks a lot for your replys.

In our customer lanscape they have following SAP R/3 vsesions 4.0B,4.5B.4.6B,4.6C,ECC 5.0,ECC 6.0

so how this unicode , non unicode settings varies with respect to versions?

Is it resembles same with respect to all the version?

Thanks & Regards,

Sasi

[former_member183906]

Some systems are Non Unicode systems.

SAP is Unicode system.

While connecting SAP to other systems and vice versa, non unicode support is required.

In that case only, In SM59 RFC destination Unicode option is selected and Unicode test must be successful.

[prateek]

Is it possible for us to Map the RFCs of non-unicode SAP system

Yes, it could be mapped. No change in mapping is required.

In the RFC destination at the sender SAP system, check the unicode option.

Regards,

Prateek