on 01-05-2009 6:43 PM
Dear all.
I'm having trouble on creating a new page format to use in a Smartform.
What I did:
1 - in tcode SPAD, created a page format called ZFPPLACA, with the possibility of portrait and landscape (457mm x 305mm and 305mm x 457mm).
2 - also in tcode SPAD, created a format type, called ZFPPLACA, of type 'S', using page format ZFPPLACA created before, with both checkboxes (Portrait and Landscape) marked in Orientation choices.
3 - also in tcode SPAD (doesn't matter for my problem I think), I added this format type to our device type ZSWIN that we use in our system.
The problem:
In my Z smartform atributes, i can choose the created ZFPPLACA from the list of available ones (which could be a good sign). However, it has a small width and lenght (I can only insert a very small window there), and cannot be used in portrait and I can't figure why!
Am I missing something?
Regards,
Valter Oliveira.
Well, this should be a system problem (refresh) because the day after, without any change in SPAD nor anyplace else, the smartforms is recognizing the page type I've created.
Thanks anyway.
Regards,
Valter Oliveira.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
80 | |
9 | |
9 | |
7 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.